Επανερχομαι. Ενισχυτης yamaha ax v401. Ηχεια b&w dm610. Νομιζω τα ηχεια ειναι στα 4 ohm. Στο manual του ενισχυτη λεει οτι μπορεις να συνδεσεις 2 ζευγη ηχειων τα οποια μπορεις να τ ακους μαζι ή χωρια.
Minimum RMS Output Power per
Channel
8 ohms, 20 Hz to 20 kHz, 0.04% THD
..............................................55W+55W
6 ohms, 20 Hz to 20 kHz, 0.06% THD
[Scandinavia and General models]
..............................................60W+60W
4 ohms, 20 Hz to 20 kHz, 0.1% THD
[Australia and U.K. models]
..............................................68W+68W
Dynamic Power per Channel
(by IHF Dynamic Headroom measuring
method)
[General model]
8/6/4/2 ohms .............85/100/120/130W
[Australia, Europe and U.K. models]
8/6/4/2 ohms .............90/105/125/140W
DIN Standard Output Power per Channel
4 ohms, 1 kHz, 0.7% THD
[Europe model only] .......................70W
IEC Power
6 ohms, 1 kHz, 0.04% THD
[Europe model only] .......................77W
Power Band Width
8 ohms, 20W, 0.1% THD
.....................................10 Hz to 40 kHz
Damping Factor
8 ohms, 1 kHz ...................................50
Input Sensitivity/Impedance
PHONO MM .............2.5 mV/47 k-ohms
CD/TUNER/LD·TV/TAPE/VCR
................................150 mV/50 k-ohms
Maximum Input Signal
(1 kHz, 0.01% THD)
PHONO MM................................80 mV
Output Level/Impedance
REC OUT .................150 mV/550 ohms
CONNECTING SPEAKERSConnect the SPEAKERS terminals to your speakers with wireof the proper gauge, cut to be as short as possible. If theconnections are faulty, no sound will be heard from thespeakers. Make sure that the polarity of the speaker wires iscorrect, that is, + and – markings are observed. If these wiresare reversed, the sound will be unnatural and will lack bass.Do not let the bare speaker wires touch each other and donot let them touch the metal parts of this unit as this coulddamage this unit and/or speakers.One or two speaker systems can be connected to this unit.If you connect only one speaker system, connect it to eitherthe SPEAKERS A or B terminals.Use speakers with the specified impedance shown on therear of this unit.
Σκεφτομαι τα magnat needle. Δεν ξερω αν αντεχει ομως ο ενισχυτης. Πρεπει να δω αν γραφει κατι απο πισω
Στάλθηκε από το SM-J510FN μου χρησιμοποιώντας Tapatalk