The light path from the lamp to the optical block is now straight as opposed to 90 degrees in the previous models...that is why the projector is deeper and the lamp removes from the rear. This change gained us some efficiency and resulted in the higher light output.
I'm sure many will opt for the RS1 or RS2 because of the case design changes. The hot air outlet is on the side now and that may be another factor in some installs.
έλα να βλέπω να αλλάζουν οι τρύπες στα ταβάνια....![]()
''Υποπτη'' η αλλαγη specs (ειδικα αναφορικα με το CR).
Άλλαξαν τσιπ, παίζει καμια ίριδα ή απλώς μπήκαν στο τριπάκι Epson κλπ (aka marketing specs);
Ίδωμεν...
I am very sorry guys that you have to wait. I was a bit too optimistic about the "few days" .
But to avoid any wild rumors: Our preview is finished and besides the not completely finished signal programming, everything looked already fine. The delay is not about any major technical issues, just about coordination...
And FYI, the minimum contrast of our PrePro started at 22,000:1, max D65 Lumens were 750. So you can start calculating now
Best Regards,
Ekkehart
Αν λένε για μετά τα Χριστούγεννα γενικα, φαντάζομαι Ελλάδα κατά το Πάσχα (κάθε Πάσχα το ιδιο deja vu ρε γμτΕχετε ακουσει τιποτε περι του ποτε θα εμφανιστει προς τα εδω ?
Αστα Γιαννη.... ΚΑΙ στο πλαι τα καλωδια ΚΑΙ παρακεντρα φακος ΚΑΙ δεν μοιαζει!!
Χλωμο με βλεπω....![]()
We use essential cookies to make this site work, and optional cookies to enhance your experience.