Lumagen RadianceXD™ Video Processor

Μπορει κανεις τωρα με το τελευταιο update να απενεργοποιησει το scaling, που οφειλεται στη μαλακη εικονα.
Ακουσα επισης οτι σκεφτονται να βαλουν και gamma 11 σημειων για ολα τα χρωματα.
Η αναβαθμιση σε 1.3 θα περιεχει δωρο μαυρη 'φατσα' και αυτακια για ρακ.
Απο τελος Ιουλιου ολ'αυτα, και μεχρι το τελος του χρονου.

Εαν καποιος περναει τον ηχο πρωτα στον ενισχυτη και μετα στον σκειλερ, δεν θα χρειαστει να κανει την 1.3 αναβαθμιση (θα μπορει και παλι να κανει ρυθμιση ανα εισοδο!).
 
Re: Απάντηση: Re: Lumagen RadianceXD™ Video Processor

Babis K. said:
Με απογοητεύεις.... Ακόμα δεν τον πήρες;
icon10.gif
Click to expand...

Παρομοια εκφραση χρησιμοποιει και η δικια μου..

Με απογοητευεις.....Ακομα δε μου τα πηρες?
 
Υπαρχει ενα μικρο προβληματακι με το colour management, το οποιο διαπιστωσα και με το δικο μου. Το προβλημα ειναι μονο στο ασπρο. Οποιος δεν το εχει χρησιμοποιησει για την ρυθμιση της φωτεινοτητας, δεν εχει προβλημα.

Κορυφη στη λιστα, αρα θα φτιαχτει εντος ημερων.
 
To καλο με αυτους Δημητρη ειναι οτι ακουν το "κοινο" τους και οποια σφαλματα, τα διορθωνουν "στο φτερο"!
Οφειλω να ομολογησω οτι μετα την τελευταια ρυθμιση του Μανωλη, η εικονα του HD-1 ειναι απολαυστικη και σχεδον καθε βραδυ βλεπω και μια ταινια!
 
Μπαμπή, τα καινούργια που κατέβασες μην τα φορτώσεις πάνε απευθείας σε αυτό…

Beta Release 050108 (replaces 043008)- Bugfix for the new vertical shift and input mask commands. Both commands were supposed to be settable per input aspect but ended up that setting it for one aspect also set it for the others. This update corrects this---however you will have to assign the masks/vertical shifts again. (rev043008 was only up for a couple of hours).
 
Απάντηση: Re: Lumagen RadianceXD™ Video Processor

GeonX said:
Μπαμπή, τα καινούργια που κατέβασες μην τα φορτώσεις πάνε απευθείας σε αυτό…

Beta Release 050108 (replaces 043008)- Bugfix for the new vertical shift and input mask commands. Both commands were supposed to be settable per input aspect but ended up that setting it for one aspect also set it for the others. This update corrects this---however you will have to assign the masks/vertical shifts again. (rev043008 was only up for a couple of hours).
Click to expand...

Πήγα Γιώργο, πήγα... Να δούμε πόσες φορές θα πάω ακόμα...
icon10.gif
 
Μπαμπη ελπιζω να μην περασες τιποτα ακομα! :p

Beta Release 050408- New method for gamut white point implemented that eliminates issue of white point affecting the colors (can slightly alter previous gamut calibrations). Another gamut correction issue that involved a calibrated gamut setup and low IRE colors not being weighted toward the color gamut (reported as oversaturated colors at low IRE) was also corrected. NLS (non-linear stretch) is now implemented for other input aspect ratios, so letterbox, 16:9, and 1.85 can be stretched for output aspects of 2.35 (or anything greater than the input aspect up to 2.45). Some usability changes made to input mask command. Zoom step command was added to the menu under "Other:Zoom step".

Α, ρε Καστρο, υπερωριες θα τραβηξεις παλι...
 
Τακης Σωτηροπουλος said:
Μπαμπη ελπιζω να μην περασες τιποτα ακομα! :p

Beta Release 050408- New method for gamut white point implemented that eliminates issue of white point affecting the colors (can slightly alter previous gamut calibrations). Another gamut correction issue that involved a calibrated gamut setup and low IRE colors not being weighted toward the color gamut (reported as oversaturated colors at low IRE) was also corrected. NLS (non-linear stretch) is now implemented for other input aspect ratios, so letterbox, 16:9, and 1.85 can be stretched for output aspects of 2.35 (or anything greater than the input aspect up to 2.45). Some usability changes made to input mask command. Zoom step command was added to the menu under "Other:Zoom step".

Α, ρε Καστρο, υπερωριες θα τραβηξεις παλι...
Click to expand...


Κάτι ξέρω εγώ που δεν έχω περάσει ΑΚΟΜΗ από τον Μπάμπη.-bye--bye-:BDGBGDB55:
 
Κανονισε μονο να του κανεις καλυτερη δουλεια απο εμενα! :p
Δεν θα ξερεις που να κρυφτεις μετα! :p
 
Εμένα μην με ανακατεύετε μ' αυτά... Είμαι απασχολημένος.


Περνάω καινούριο firmware...
 
Beta Release 050508- Bugfix for NLS used with 16:9 (wouldn't allow you to press 16:9 again to turn off NLS) and other aspects with NLS wouldn't turn off NLS if the previous input aspect was 2.35.
 
Εφτασαν τα πρωτα Production Candidate Releases!

-Production Candidate 052608- Bugfix for 052508 revision that for some configurations would give no video.

-Production Candidate 052508- Adds YC delay command under "Input:Video Setup:RES:Picture". Adds vertical refresh rate selection to timing menu but limited to 50 or 59.94 Hz currently. Bugfix for vertical resolution issue where it would get stuck at 480/576 instead of the correct resolution. Other bugfixes.
 
Production Candidate 060108- Bugfix for problems with snow/menu noise on some systems. Fixed a couple of small issues with the gamut:bycolor test patterns. Bugfix for intermittent vertical line on left side of screen that was in a few recent revs of software and could occur in situations when horizontal scaling was not needed. Fixed the Vertical Shift command to use "Exit" to cancel and "OK" to accept. Most text color in menus is now either white or yellow, eliminating black in all but a few places. Other small bugfixes
 
Production Release!

Production 060808- Fix for occasional burst of audio static when switching between some sources on the Radiance and driving a Lexicon MC-12HD. Fix for occasional dropping of coax audio using MC-12HD. These 2 fixes can apply to similar problems driving other audio equipment but we were testing with the MC-12HD. Bugfix for Scart input corrupting svideo/composite inputs when switching between these inputs. Added wrap around for going up/down the menus. Added "Input Reselect" command in the menu under Other:Menu Control. The default behavior (set to On) is to reinitialize settings and display the input name when reselecting an input.
 
Production 061208- Bugfix for lower IRE gamma calculations which were sometimes bad enough to cause visible problems. Enhanced the function of the output aspect per input aspect functionality with NLS. Now, when selecting NLS with 4:3 input aspect the output aspect assigned to the 16:9 input aspect entry will be used and when selecting Lbox,16:9, and 1.85 input aspects with NLS the output aspect assigned to the 2.35 input aspect entry is used. Another small enhancement for input aspects Lbox,16:9, and 1.85 when modified with NLS will now assert an output trigger if the output trigger had been programmed to trigger for 2.35 input aspect.
 
Production 071108- Adds virtual inputs for HDMI inputs. This allows assigning input memories to different physical inputs--so you could assign input memory 1A to physical input 3 for instance. Input assignments can be made in the menu under Input:HDMI Setup:Physical In. Adds a command to disable/enable up/down arrows on remote used for zooming. Find this command in the menu under "Other:Zoom Setup". Some minor bugfixes.

http://www.lumagen.com/docs/Radiance_071108.zip :ernaehrung004:
 
Top Bottom